Description

MX25L1005ZUI-12G is a CMOS 1,048,576 bit serial Flash memory with a serial peripheral interface and software protocol. It is configured as 131,072 x 8 internally and provides sequential read operation on the whole chip. The memory cell used in this model is reliable and can endure up to 100,000 program and erase cycles. It operates on a single power supply of 2.7 to 3.6 volts for read, erase, and program operations. The MX25L1005ZUI-12G consumes low power and enters standby mode when not in operation.

Specifications and features

General

• Serial Peripheral Interface (SPI) compatible -- Mode 0 and Mode 3
• 1,048,576 x 1 bit structure
• 32 Equal Sectors with 4K byte each - Any Sector can be erased individually
• 2 Equal Blocks with 64K byte each - Any Block can be erased individually
• Single Power Supply Operation - 2.7 to 3.6 volt for read, erase and program operations
• Latch-up protected to 100mA from -1V to Vcc +1V
• Low Vcc write inhibit is from 1.5V to 2.5V

Performance

• High Performance - Fast access time: 85MHz serial clock (15pF + 1TTL Load) and 66MHz serial clock (30pF + 1TTL Load) Fast program time: 1.4ms(typ.) and 5ms(max.)/page (256-byte per page) Fast erase time: 60ms(typ.) and 120ms(max.)/sector (4K-byte per sector) ; 1s(typ.) and 2s(max.)/block (64K-byte per block)
• Low Power Consumption - Low active read current: 12mA(max.) at 85MHz, 8mA(max.) at 66MHz and 4mA(max.) at 33MHz Low active programming current: 15mA (max.) Low active erase current: 15mA (max. Low standby current: 10uA (max.) Deep power-down mode 1uA (typical)
• Minimum 100,000 erase/program cycles

Application Scenarios

This model is commonly used in electronic devices that require high-performance and low power consumption memory components. It is suitable for applications such as industrial control systems, consumer electronics, communication devices, and automotive electronics.

Comparison

• Reliable memory cell that can endure up to 100,000 program and erase cycles
• Low power consumption with low standby current
• High performance with fast access, program, and erase times
• Compatible with SPI interface and software protocol

• Requires a single power supply of 2.7 to 3.6 volts
• Latch-up protected to 100mA from -1V to Vcc +1V