Description

Electronic Component Model: PIC18LF25K80-I/SS is a microcontroller that belongs to the PIC18F66K80 family. This family of microcontrollers combines high computational performance and a rich feature set while offering a competitive price point. It is an ideal choice for high-performance applications where price is a primary consideration.

Specifications and Features

• Power-Managed Modes:
  • Run: CPU on, Peripherals on
  • Idle: CPU off, Peripherals on
  • Sleep: CPU off, Peripherals off
  • Two-Speed Oscillator Start-up
  • Fail-Safe Clock Monitor (FSCM)
  • Power-Saving Peripheral Module Disable (PMD)
  • Ultra Low-Power Wake-up
  • Fast Wake-up, 1µs, Typical
  • Low-Power WDT, 300 nA, Typical
  • Run mode Currents Down to Very Low 3.8µA, Typical
  • Idle mode Currents Down to Very Low 880nA, Typical
  • Sleep mode Current Down to Very Low 13nA, Typical
• ECAN Bus Module Features:
  • Conforms to CAN 2.0B Active Specification
  • Three Operating modes:
    • Legacy mode (full backward compatibility with existing PIC18CXX8/FXX8 CAN modules)
    • Enhanced mode
    • FIFO mode or programmable TX/RX buffers
  • Message Bit Rates up to 1 Mbps
  • DeviceNet™ Data Byte Filter Support
  • Six Programmable Receive/Transmit Buffers
  • Three Dedicated Transmit Buffers with Prioritization
  • Two Dedicated Receive Buffers
  • 16 Full, 29-Bit Acceptance Filters with Dynamic Association
  • Three Full, 29-Bit Acceptance Masks
  • Automatic Remote Frame Handling
  • Advanced Error Management Features
• Special Microcontroller Features:
  • Operating Voltage Range: 1.8V to 5.5V
  • On-Chip 3.3V Regulator
  • Operating Speed up to 64 MHz
  • Up to 64 Kbytes On-Chip Flash Program Memory:
    • 10,000 erase/write cycle, typical
    • 20 years minimum retention, typical
  • 1,024 Bytes of Data EEPROM:
    • 100,000 Erase/write cycle data EEPROM memory, typical
  • 3.6 Kbytes of General Purpose Registers (SRAM)
  • Three Internal Oscillators: LF-INTOSC (31 KHz), MF-INTOSC (500 kHz) and HF-INTOSC (16 MHz)
  • Self-Programmable under Software Control
  • Priority Levels for Interrupts
  • 8 x 8 Single-Cycle Hardware Multiplier
  • Extended Watchdog Timer (WDT):
    • Programmable period from 4 ms to 4,194s
  • In-Circuit Serial Programming™ (ICSP™) via Two Pins
  • In-Circuit Debug via Two Pins
  • Programmable BOR
  • Programmable LVD

Application Scenarios

The PIC18LF25K80-I/SS microcontroller is suitable for a wide range of applications including but not limited to:

• Embedded Systems
• Automation
• IoT (Internet of Things)
• Sensor Networks
• Industrial Control

Comparison

• Advantages:
• High computational performance
• Rich feature set
• Competitive price point
• Disadvantages:
• None identified