ADE7755ARSRL

GENERAL DESCRIPTION

The ADE7755 is pin compatible with the AD7755. The only difference between the ADE7755 and the AD7755 is that the ADE7755 features a synchronous CF and F1/F2 outputs under all load conditions.
The ADE7755 is a high accuracy electrical energy measurement IC. The part specifications surpass the accuracy requirements as quoted in the IEC1036 standard. See Analog Devices’ Application Note AN-559 for a description of an IEC1036 watt-hour meter reference design based on the AD7755.
The only analog circuitry used in the ADE7755 is in the ADCs and reference circuit. All other signal processing (e.g., multiplication and filtering) is carried out in the digital domain. This approach provides superior stability and accuracy over extremes in environmental conditions and over time.

FEATURES

High Accuracy, Supports 50 Hz/60 Hz IEC 687/1036
Less than 0.1% Error over a Dynamic Range of 500 to 1
The ADE7755 Supplies Average Real Power on the Frequency Outputs F1 and F2
The High-Frequency Output CF Is Intended for Calibration and Supplies Instantaneous Real Power
Pin Compatible with AD7755 with Synchronous CF and F1/F2 Outputs
The Logic Output REVP Can Be Used to Indicate a Potential Miswiring or Negative Power
Direct Drive for Electromechanical Counters and Two Phase Stepper Motors (F1 and F2)
A PGA in the Current Channel Allows the Use of Small Values of Shunt and Burden Resistance
Proprietary ADCs and DSP Provide High Accuracy over Large Variations in Environmental Conditions and Time
On-Chip Power Supply Monitoring
On-Chip Creep Protection (No Load Threshold)
On-Chip Reference 2.5 V ± 8% (30 ppm/°C Typical) with External Overdrive Capability
Single 5 V Supply, Low Power (15 mW Typical)
Low Cost CMOS Process