SN8P2202XG

PRODUCT OVERVIEW

SN8P2614 is a 28 pin general purpose MCU with internal high RC 16MHz and 200mA sink current @VSS+1.5V of Port 2. The combination of Port 1 and Port 2 is for LED panel scan with large current design. Internal high RC 16MHz provides more I/O pin and low cost high clock oscillator selection. SN8P2614 has unique pin assignment not compatible with SN8P2604 or SN8P2604A. The system is base on 4T design for high noisy application, e.g. household products...

FEATURES

♦ Memory configuration
OTP ROM size: 6K * 16 bits.
RAM size: 192 * 8 bits.
♦ 8 levels stack buffer
♦ I/O pin configuration
Bi-directional: P0, P1, P2, P5.
Wakeup: P0, P1 level change trigger.
Pull-up resisters: P0, P1, P2, P5.
External Interrupt trigger edge:
P0.0 controlled by PEDGE register.
P0.1 is falling edge trigger only.
Each of P2 sink current: 200mA @VSS+1.5V.
♦ 3-Level LVD.
Reset system and power monitor.
♦ Four interrupt sources
Two internal interrupts: T0, TC1.
One external interrupts: INT0, INT1.
♦ Powerful instructions
Four clocks per instruction cycle (4T)
One instructions length is one word.
Most of instructions are one cycle only.
All ROM area JMP instruction.
All ROM area CALL address instruction.
All ROM area lookup table function (MOVC)
♦ Two 8-bit Timer/Counter
T0: Basic timer
TC1: Auto-reload timer/Counter/PWM/Buzzer output
♦ One channel PWM output. (PWM1).
♦ One channel Buzzer output. (BZ1).
♦ On chip watchdog timer and clock source is internal low clock RC type (16KHz @3V, 32KHz @5V).
♦ Four system clocks
External high clock: RC type up to 10 MHz
External high clock: Crystal type up to 16 MHz
Internal high clock: 16MHz RC type.
Internal low clock: RC type 16KHz(3V), 32KHz(5V)
♦ Four operating modes
Normal mode: Both high and low clock active
Slow mode: Low clock only
Sleep mode: Both high and low clock stop
Green mode: Periodical wakeup by T0 Timer
♦ Package (Chip form support)
SK-DIP 28 pins
SOP 28 pins.
SSOP 28 pins.