ST10F272M-4QR3

Description

The ST10F272M device is a new derivative of the STMicroelectronics ST10 family of 16-bit single-chip CMOS microcontrollers.
The ST10F272M combines high CPU performance (up to 20 million instructions per second) with high peripheral functionality and enhanced I/O capabilities. It also provides on-chip high-speed single voltage Flash memory, on-chip high- speed RAM, and clock generation via PLL.
The ST10F272M is processed in 0.18mm CMOS technology. The MCU core and the logic is supplied with a 5V to 1.8V on-chip voltage regulator. The part is supplied with a single 5V supply and I/Os work at 5V.
The ST10F272M is an optimized version of the ST10F272E, upward compatible with the following set of differences:

● Maximum CPU frequency is 40 MHz

● Reduced range for the Standby Voltage: VStby must be in the range of 4.5 to 5.5V.
● Identification registers: the IDMEM register reflects the Flash type difference and can be used to differentiate the two devices by software
● Improved EMC behavior thanks to the introduction of an internal RC filter on the 5V for the ballast transistors

Features

■ 16-bit CPU with DSP functions
– 50ns instruction cycle time at 40 MHz max CPU clock
– Multiply/accumulate unit (MAC) 16 x 16-bit multiplication, 40-bit accumulator
– Enhanced boolean bit manipulations
– Single-cycle context switching support
■ On-chip memories
– 256 Kbyte Flash memory (32-bit fetch)
– Single voltage Flash memories with erase/program controller and 100K erasing/programming cycles.
– Up to 16 Mbyte linear address space for code and data (5 Mbytes with CAN or I2C)
– 2 Kbyte internal RAM (IRAM)
– 18 Kbyte extension RAM (XRAM)
– Programmable external bus configuration & characteristics for different address ranges
– 5 programmable chip-select signals
– Hold-acknowledge bus arbitration support
■ Interrupt
– 8-channel peripheral event controller for single cycle interrupt driven data transfer
– 16-priority-level interrupt system with 56 sources, sampling rate down to 25ns
■ Timers
– 2 multi-functional general purpose timer units with 5 timers
■ Two 16-channel capture / compare units
■ Serial channels
– 2 synch. / asynch. serial channels
– 2 high-speed synchronous channels
– One I2C standard interface
■ 24-channel A/D converter
– 16-channel 10-bit, accuracy +/-2LSB
– 8-channel 10-bit, accuracy +/-5LSB
– 4.85 µs minimum conversion time
■ 4-channel PWM unit + 4-channel XPWM
■ 2 CAN 2.0B interfaces operating on 1 or 2 CAN busses (64 or 2x32 message, C-CAN version)
■ Fail-safe protection
– Programmable watchdog timer
– Oscillator watchdog
■ On-chip bootstrap loader
■ Clock generation
– On-chip PLL with 4 to 8 MHz oscillator
– Direct or prescaled clock input
■ Real time clock and 32 kHz on-chip oscillator
■ Up to 111 general purpose I/O lines
– Individually programmable as input, output or special function
– Programmable threshold (hysteresis)
■ Idle, power-down and stand-by modes
■ Single voltage supply: 5V ±10% (embedded regulator for 1.8V core supply)
■ Temperature range: -40 to +125°C