MPC5200VR400

Overview

The MPC5200B integrates a high performance MPC603e series e300 core with a rich set of peripheral functions focused on communications and systems integration. The e300 core design is based on the PowerPC® core architecture. MPC5200B incorporates an innovative BestComm I/O subsystem, which isolates routine maintenance of peripheral functions from the embedded e300 core. The MPC5200B contains a SDRAM/DDR Memory Controller, a flexible External Bus Interface, PCI Controller, USB, ATA, Ethernet, six Programmable Serial Controllers (PSC), I2C, SPI, CAN, J1850, Timers, and GPIOs.

Features

Key features are shown below.
• MPC603e series e300 core
— Superscalar architecture
— 760 MIPS at 400 MHz (-40 to +85 oC)
— 16 k Instruction cache, 16 k Data cache
— Double precision FPU
— Instruction and Data MMU
— Standard and Critical interrupt capability
• SDRAM / DDR Memory Interface
— up to 133-MHz operation
— SDRAM and DDR SDRAM support
— 256-MByte addressing range per CS, two CS available
— 32-bit data bus
— Built-in initialization and refresh
• Flexible multi-function External Bus Interface
— Supports interfacing to ROM/Flash/SRAM memories or other memory mapped devices
— 8 programmable Chip Selects
— Non multiplexed data access using 8/16/32 bit databus with up to 26-bit address
— Short or Long Burst capable
— Multiplexed data access using 8/16/32 bit databus with up to 25-bit address
• Peripheral Component Interconnect (PCI) Controller
— Version 2.2 PCI compatibility
— PCI initiator and target operation
— 32-bit PCI Address/Data bus
— 33- and 66-MHz operation
— PCI arbitration function
• ATA Controller
— Version 4 ATA compatible external interface—IDE Disk Drive connectivity
• BestComm DMA subsystem
— Intelligent virtual DMA Controller
— Dedicated DMA channels to control peripheral reception and transmission
— Local memory (SRAM 16 kBytes)
• 6 Programmable Serial Controllers (PSC), configurable for the following:
— UART or RS232 interface
— CODEC interface for Soft Modem, Master/Slave CODEC Mode, I2S and AC97
— Full duplex SPI mode
— IrDA mode from 2400 bps to 4 Mbps
• Fast Ethernet Controller (FEC)
— Supports 100Mbps IEEE 802.3 MII, 10 Mbps IEEE 802.3 MII, 10 Mbps 7-wire interface
• Universal Serial Bus Controller (USB)
— USB Revision 1.1 Host
— Open Host Controller Interface (OHCI)
— Integrated USB Hub, with two ports.
(Continue ...)